Fitting The Cooling Unit - Rittal CS 9761.212 Montageanleitung Und Bedienungsanleitung

4 Assembly and connection

4.3 Fitting the cooling unit

EN
Outdoor cooling units from RITTAL are specifically
tailored to the twin-walled outdoor enclosure sys-
tems CS Toptec and CS modular enclosures.
The cooling units are supplied fitted on the outdoor
enclosure.
If self-installed, a cut-out must be made in the door,
wall or roof in accordance with the mounting cut-out
(cf. Fig. 2 – 4) in the inner and outer door or wall or in
the roof of the basic enclosure. The cooling unit is
secured using the M6 screw-fixing points provided in
the cooling unit enclosure.
75 70
120
165
483
513
Fig. 2: Mounting cut-out CS 9761.212
Fig. 3: Mounting cut-out CS 9768.152
28
1
40
2
3
1
Rivet nut M8
(solid version)
50
2
Outer contour
3
Enclosure centre
8
340
360
400
77
7.5
1
2
456
1
Cut-out
Fig. 4: Mounting cut-out CS 9762.212
1
Seal
2
Cut-out
2
Fig. 5: Assembly sequence CS 9762.212
Note:
Mounting frame required for
roof-mounted cooling unit CS 9762.212
A mounting frame CS 9765.051 and a cli-
mate control cover, tailored to the width and
depth of the enclosure, are required for
mounting the roof-mounted cooling unit
CS 9762.212 on the CS modular enclosure.
Use on enclosures in the CS Toptec series
is not supported.
RITTAL outdoor cooling unit assembly and operating instructions
217
7.5
1
58
228
398
2
Rivet nut M5
1
1