Fitting The Outlet Protection Grille - Rittal Blue e+ Montageanleitung

6 Fitting the outlet protection grille

EN
26

Secure the air duct onto the horizontal part using four Polystop nuts (Polystop
nut M5) each with one contact washer (contact washer NZ/5.1 serrated)
(fig. 21).
The tightening torque for the nuts is 5 Nm.
The top edge of the seal is flush with the top edge of the air duct end piece.
Fig. 21: Install the vertical air duct part
6 Fitting the outlet protection grille
It is left to the customer's discretion whether or not to fit a protective grille onto
the air duct outlet.

First cut the seal provided (seal W10 x H4 x L1000 mm) to fit.

Then attach it to the contact surface between the protective grille and the air
duct cover at the front (fig. 22).
Fig. 22: Protective grille seal
Initially, the protective grille is held in place by the four cut-outs on the outlet
(fig. 23).
Rittal air duct Blue e+