eQ-3 homematic IP Home Control Unit HmIP-HCU1 Installations- Und Bedienungsanleitung Seite 31

RestHringftHrlsettings
9 RestHringftHrlsettings
Resetting the Home Control Unit
resets the entire Homematic IP
installation. Afterwards, the facto-
ry state of your individual
Homematic IP devices must be
restored to enable them to be
paired again.
9.1 Resetting the Home Control Unit
To restore the factory settings of the
Home Control Unit, proceed as fol-
lows:
• Disconnect the Home Control Unit
from the power supply by unplug-
ging the mains adapter.
• Plug the mains adapter back in.
• Wait until the top LED is switched
o and the status LEDs light up.
• Now press the system button for
5 seconds until the top LED ashes
orange quickly.
• Release the system button.
• Press the system button again for
5 seconds until the top LED starts
ashing green quickly. If the LED
lights up red, please try again.
• Release the system button to con-
clude the procedure.
The device will perform a restart and
the Home Control Unit is reset.
This process must be carried out
within 5 minutes of starting the
Home Control Unit.
10 Mintennendening
The device does not require you
to carry out any maintenance.
Leave any maintenance or repair
to a specialist.
Clean the device using a soft, clean,
dry and lint-free cloth. Dampen the
cloth a little with lukewarm water to
remove more stubborn marks. Do not
use any detergents containing sol-
vents, as they could corrode the plastic
housing and label.
11 GenerinfHrtiHnaHut
rdiHHmertiHn
Radio transmission is performed on
a non-exclusive transmission path,
which means that there is a possibility
of interference occurring. Interference
can also be caused by switching ope-
rations, electrical motors or defective
electrical devices.
The transmission range within
buildings can dier signicantly
from that available in open space.
Besides the transmitting power
and the reception characteristics
of the receiver, environmental
factors such as humidity in the
vicinity play an important role, as
do on-site structural/screening
conditions.
eQ-3 AG, Maiburger Straße 29, 26789
Leer, Germany hereby declares that the
radio equipment type Homematic IP
HmIP-HCU1, HmIP-HCU1-A is compli-
ant with Directive 2014/53/EU. The full
text of the EU declaration of conformi-
ty can be found at:
www.homematic-ip.com
31