eQ-3 homematic IP Home Control Unit HmIP-HCU1 Installations- Und Bedienungsanleitung Seite 27

TrHuaeshHHting
You can also access the HCUweb via
the IP address of the Home Control
Unit.
You can use your router or the
"NetFinder" add-on software to
nd out the IP address.
7.5 First steps: Pairing devices and
adding rooms
As soon as your Homematic IP Home
Control Unit and the Homematic IP
app are ready for use, you can add
additional Homematic IP devices and
allocate them in the app to dierent
rooms.
• Tap on the main menu symbol "...
More" at the bottom right of the
home screen, and then on "Pair
device".
• Establish the power supply of the
Homematic IP device you want to
add to activate the pairing mode.
For further information, please re-
fer to the operating manual of the
corresponding device.
• Follow the instructions of the app
step by step.
• Select the desired solution for your
device.
• In the app, give the device a name
and create a new room or allocate
the device to an existing room.
Please dene the device names
very carefully to avoid assignment
errors when using various devices
of the same type. You can change
the device and room names at any
time.
7.6 Operation and conguration
Once you have successfully paired
your Homematic IP device and added
rooms, you can conveniently control
and congure your Homematic IP
system. You will nd more detailed
information on operating the app and
conguring the Homematic IP sys-
tem in the Homematic IP User Guide
(available in the Downloads area of our
website www.homematic-ip.com).
8 TrHuaeshHHting
8.1 Command not conrmed
If at least one receiver does not con-
rm a command, this may be caused
by radio interference
information about radio operation" on
page 31).
The error will be displayed in the app
and may be cause by the following:
• Receiver cannot be reached
• Receiver is unable to execute the
command (load failure, mechanical
blockade, etc.)
• Receiver is defective
(see „11 General
27