eQ-3 homematic IP Home Control Unit HmIP-HCU1 Installations- Und Bedienungsanleitung Seite 26

trt-um
• Select your home network and en-
ter your password.
.........
.........
.........
Figure 20
• Reconnect your end device to your
home network.
.........
.........
.........
Figure 21
• Wait until all three status LEDs on
your Home Control Unit light up
blue continuously.
Figure 22
If the top LED lights up dierently
see „8.3 Error codes and ashing
sequences" on page 29
low the instructions in the app.
Homematic IP
WLAN
Homematic IP
WLAN
or fol-
• Complete the installation steps in
the Homematic IP app.
• The Home Control Unit is now set
up and ready for use.
7.4 HCUweb
You can use the "HCUweb" web service
to make special network settings for
the Home Control Unit or to link part-
ner solutions.
HCUweb can only be accessed via
the local network and not via the
Internet.
The HCUweb features the following
settings and functions:
• Network settings (DNS / static IP)
for connection via network cable
and WLAN
• Backups
• USB memory management
• Plug-in management
• Update conguration
• Display of system information
• Conguration online/oine mode
Activate the USB stick in the HCU-
web interface to be able to use
the backup function, measure-
ment data acquisition and plug-
ins.
The HCUweb is not a program-
ming interface and does not re-
place the Homematic IP app.
You can access HCUweb in the local
network at:
https://hcu1-XXXX.local (XXXX
bes the last four digits of the SGTIN).
The SGTIN can be found on the under-
side of the Home Control Unit
gure).
descri-
(see
26