Keys And Display; Setting The Language - Ergosana Sana Bike 320 F Gebrauchsanweisung

4.2.1

Keys and Display

The display shows all operating and measuring procedures. When the unit is switched on, the
basic menu is displayed. The desired menu option is selected using the arrow keys.
The right and left buttons on the control panel have been arranged so that the function
executed by the corresponding key is shown directly above the key on the lower side of the
display. The desired menu option is opened by pressing the respective key. All menu options
required for the correct operation of the device are located in the "Settings" menu. The settings
in this menu should only be defined by service technicians and trained stuff. All further setting
options are described in section 6.
During an exercise recording, the current load curve is displayed (trend graph). If the heart rate
is loaded (optional), it will also be displayed with a different line width than the load curve. This
makes the monitoring of the load parameters during a stress test particularly easy.
The upper part of the display is alphanumeric. This part contains several boxes indicating the
current speed, the current load, the running period and, if the measurement option is installed,
the current heart rate.
It is possible to change the display mode from Trend graph to Numerical. See page 18 Menu
Settings/Display mode.
1
1 = Confirmation key
2 = "Up" and "down" cursor keys
3 = LCD display
4.2.2

Setting the Language

The preset menu language is "deutsch".
To change the language, highlight the "Einstellungen" menu option using the "ab" arrow, and
confirm with "OK".
In the "Einstellungen" menu, select the "Sprache" option and confirm with "OK". Then select the
desired language using the "auf" or "ab" arrow, and confirm with "OK".
The menu is now displayed in the selected language.
Article no.: 2.520091 Rev.: b
Sana Bike 320 F
3
2
1
Page 10 of 22