Spokey ERIN 944169 Bedienungsanleitung Seite 10

MAINTENANCE INSTRUCTION
WARNING:
Always unplug the treadmill before
cleaning or maintenance.
CLEANING THE TREADMILL
Do not neglect regular maintenance, it will extend
the life of the device. Damage caused by insuffi-
cient care of the device is not covered by the war-
ranty! Keep your treadmill clean by vacuuming it reg-
ularly. Be sure to clean the exposed parts of the deck
on both sides of the walking belt, as well as the side
platforms. Keep your running shoes clean to prevent
foreign objects from accumulating under the run-
ning belt.
• Clean the treadmill, console frame and running
surface once a week with a damp, soft cloth. Also
remember to remove dust from under the tread-
mill. Do not use paper towels - they are rough
and may damage the surfaces being cleaned.
• The area under the treadmill motor cover
should be cleaned of dust and dirt regularly
every month. The area under the treadmill motor
cover should be cleaned of dust and dirt regularly
every month.
Instructions for removing dirt from under the en-
gine cover:
1. Turn off the treadmill and unplug it from the power
source.
2. Unscrew the engine cover on all sides.
3. Use compressed air or a soft bristle brush to re-
move dust and other debris.
4. Then vacuum the dirt very carefully with a vacuum
cleaner.
5. After cleaning the device in the engine compart-
ment, screw the engine cover back on.
RUNNING BELT
AND RUNNING BOARD LUBRICATION
• The walking belt and board are already pre-lubri-
cated. Friction between the belt and the board can
play an important role in the operation and life of the
treadmill, and regular lubrication is required.
• It is recommended to regularly check the condition
of the board.
EN | 10
• If you notice any damage, contact our service.
• WARNING: All repairs should be carried out
by a specialist.
• Only use grease intended for this purpose!
The set includes one bottle of silicone oil.
• If you exercise on a treadmill for at least an hour
a day, you should lubricate the treadmill once
a month, and if you use it less frequently, once ev-
ery three months is enough. It is best to lubricate
the treadmill after every 30 hours of use.
Treadmill lubrication instructions:
BANDA RUNNING BELT
TABLA BOARD
1. Turn off the treadmill and unplug it from the power
source.
2. Loosen the walking belt itself so that you have easy
access to the rear rollers (it is important to remem-
ber how many turns of the wrench were made when
loosening the running belt).
3. Use a small amount of lubricant (max 5 ml) or spray
gel to avoid damaging the treadmill mechanism. Too
much will cause excessive belt slippage and grease
may settle on the engine, causing it to overheat.
Flooding of the belt, countertop, engine or elec-
tronics is not subject to complaint.
4. Re-tighten the belt (turn the key in the opposite
direction exactly the number of times you did when
loosening the belt - center the belt if necessary).
5. After lubricating, do not use the treadmill and first
run it at a low speed (about 2-3 km/h) for a few min-
utes to spread the lubricant over the entire length
of the belt.
Once the belt is lubricated, the treadmill is ready for use.
WARNING: Improper or incomplete
maintenance of the cardio fitness device
is not covered by the warranty!
user manual