Herunterladen Inhalt Inhalt Diese Seite drucken

Caring For The Dishwasher - Whirlpool ADG 190 A+ Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für ADG 190 A+:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Remarks:
- Inspect the filters for blockages every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
NOTE: The entire filter assembly should be cleaned once a week.
Cleaning the Filter
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in
the figures on the previous page and reinsert the entire assembly in the dishwasher, positioning it in its
seat and pressing downwards.
WARNING:
When cleaning the filters, do not knock them. Otherwise, the filters could be contorted and the
performance of the dishwasher could be compromised.

Caring for the Dishwasher

The control panel can be cleaned by using a lightly dampened cloth. After cleaning, dry it thoroughly.
For the exterior, use a good appliance polish wax. Never use sharp objects, scouring pads or harsh
cleaners on any part of the dishwasher.
Cleaning the Door
To clean the edge around the door, you should use only a soft cloth
dampened with warm water. To avoid penetration of water into the
door lock and electrical components, do not use a spray cleaner of
any kind.
WARNING:
• Never use a spray cleaner to clean the door panel as it may damage the door lock and electrical
components.
• Abrasive agents and certain paper towels should not be used because of the risk of scratching or
leaving spots on the stainless steel surface.
Protecting against Freezing
Please take frost protection measures on the dishwasher in winter. After every washing cycle, proceed as
follows:
1. Cut off the power supply to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve (use a pan to catch the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
NOTE: If your dishwasher cannot work due to a build-up of ice, please contact the authorised after sales
service.
50

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis