Loading The Racks; Lower Rack; Upper Rack - Whirlpool WBO 3T133 PF X Bedienungsanleitung

LOADING THE RACKS

CUTLERY RACK
Knives and other utensils with sharp edges must be positioned
with the blades facing downwards.

UPPER RACK

(loading example for the upper rack)
ADJUSTING THE HEIGHT OF THE UPPER RACK
The height of the upper rack can be adjusted: high position to place bulky
crockery in the lower basket and low position to make the most of the
tip-up supports by creating more space upwards and avoid collision with
the items loaded into lower rack.
The upper rack is equipped with a Upper Rack
height adjuster (see figure), without pressing
the levers, lift it up by simply holding the rack
sides, as soon as the rack is stable in its upper
position. To restore to the lower position, press
the levers A at the sides of the rack and move the
basket downwards.
We strongly recommend that you do not ad-
just the height of the rack when it is loaded.
NEVER raise or lower the basket on one side
only.
The third rack was designed to
house the cutlery.
Arrange the cutlery as shown in the
figure.
A separate arrangement of the
cutlery makes collection easier after
washing and improves washing and
drying performance.
The geometry of the rack makes it
possible to place such small items
as coffee cups in the area in the
middle.
Load delicate and light dishes: glas-
ses, cups, saucers, low salad bowls.
FOLDABLE FLAPS WITH ADJUSTABLE POSITION
The side foldable flaps can be fold or
unfold to optimize the arrangement
of crockery inside the rack. Wine
glasses can be placed safely in the
foldable flaps by inserting the stem
of each glass into the corresponding
slots.
Depending on the model:
– to unfold the flaps there is needed
to slide it up and rotate or release
it from the snaps and pull it down.
– to fold the flaps there is needed
to rotate it and slide flaps down or
pull it up and attach flaps to the snaps.

LOWER RACK

For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids should
ideally be placed at the sides to avoid interferences with the spray arm.
The lower rack has tip-up supports which can be used in a vertical po-
sition when arranging plates or in a horizontal position (lower) to load
pans and salad bowls easily.
(loading example for the lower rack)
POWER CLEAN®
Power Clean® uses the special water
jets in the rear of cavity to wash more
intensively the high dirty items. The
lower rack has a Space Zone, a special
pull-out support in the rear of the rack
that can be used to support frying
pans or baking pans in upright position, thus taking up less space.
Placing the pots/casseroles faced to the Power Clean® component please
activate the POWER CLEAN® on the panel.
How to use Power Clean®:
1. Adjust the Power Clean® area G
folding down the rear plate hol-
ders to load pots.
2. Load pots and casseroles inclined
vertically in Power Clean® area.
Pots have to be inclined towards
the power water jets.
EN
5