Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BEFORE USING FOR THE FIRST TIME
Before using your dishwasher for the first time:
A. Set the water softener
B. Add 1.5 kg dishwasher salt and then full fill the salt container with water
C. Fill the rinse aid dispenser
D. Add detergent
A. Water Softener
The water softener must be set manually, using the water hardness dial. The water softener is designed to
remove minerals and salts from the water, which would have a detrimental or adverse effect on the
operation of the appliance. The higher the content of these minerals and salts, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your local Water
Board can advise you on the hardness of the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness
of the water used. This is intended to optimise and customise the level of salt consumption.
Please follow the steps below for adjustment of salt consumption.
1. Unscrew the cap from the salt container.
2. There is a ring on the container with an arrow on it (see adjacent
figure), if necessary, rotate the ring anticlockwise from the "-" setting
toward the "+" sign, based on the hardness of the water being used.
It is recommended that adjustments should be made in accordance with
the following scheme:
WATER HARDNESS
°dH
°fH
0~8
0~14
8~22
14~39
22~45
39~80
45~60
80~107
Note 1
°dH
= 1.25
°Clarke = 1.78
°fH
= 0.178 mmol/l
°dH
= German degree
°fH
= French degree
°Clarke = British degree
Contact your local water board for information on the hardness of your water supply.
°Clarke
mmol/l
0~10
0~1.4
10~28
1.4~3.9
28~56
3.9~8
56~75
8~11
Note 2
/
= No additional salt required
–
= Setting toward the"-" sign
+
= Setting toward the"+" sign
Mid = Setting between the "-" sign and "+" sign
37
Salt
Selector
consumption
position
(gram/cycle)
/
0
–
20
Mid
40
+
60
Autonomy
(cycles/1kgs)
/
50
25
16
Werbung
Inhaltsverzeichnis
