Whirlpool ADG 190 A+ Gebrauchsanweisung Seite 62

Unsatisfactory drying result
Problem Possible causes
The dishes are not Incorrect loading
drying
Too little rinse aid
Dishes are removed too
soon
Wrong program has been
selected
Use of cutlery with a
low-quality coating
Error codes
When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings
E1 Long inlet time
E3 Long heating time, but not
reaching required
temperature
E4 Overflow
E6 Failure of temperature
sensor
E7 Failure of temperature
sensor
WARNING:
• If overflow occurs, turn off the mains water supply before calling for service.
• If there is water in the base tray because of an overfill or small leak, the water should be
removed before restarting the dishwasher.
What to do
Load the dishwasher as suggested in the directions.
Increase the amount of rinse aid/refill the rinse aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once the
dishes are barely warm to the touch. Empty the lower
rack first. This prevents water from dripping off dishes
in the upper rack.
In short programs the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a longer washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Possible causes
Faucets is not opened, or water intake is restricted, or
water pressure is too low.
Malfunctioning of temperature sensor or of heating
element.
Some element of dishwasher leaks
Open circuit or break of temperature sensor
Short circuit or break of temperature sensor
62