Mopping Mode; Preparing The Water Tank - Medion X42 Sw+ Bedienungsanleitung

 Press the
button again to pause the
cleaning process.
 Press the
button again to continue
cleaning.
 Press the
button for approx. 5
seconds or the
control to switch off the robot vacuum
and mop completely.
 With the appliance switched off, clean
the suction opening at regular intervals
and empty the dust container after every
use.

9. Mopping mode

NOTICE!
Possible damage to property!
Floor coverings may be damaged by leaking
water/liquids.
 Only use the robot vacuum and mop in
mopping mode on tiles and sealed floor
surfaces, not on carpets.
NOTICE!
Possibility of damage to the appliance!
Unsuitable additives in the water can cause
damage to the appliance.
 You can add a commercially available,
non-foaming floor cleaning agent
to the water. Follow the detergent
manufacturer's dosing instructions.
156
button on the remote
9.1. Preparing the water
tank
The appliance can be converted into a robot
mop using the accessories supplied.
Fig. 16 – Removing the dust container/
water tank
 Remove the dust container/water tank.
Fig. 17 – Filling the water tank
 Open the cap on the water tank.
 Fill the water tank with clean water.
 Close the cap on the water tank.
 Moisten the wiping cloth with water and
wring it out until it stops dripping.
Fig. 18 – Assembling the mop attachment
 Slide the wiping cloth into the guide rail
of the mop attachment.