Ego Power+ ZERO TURN ZT4200E-S Bedienungsanleitung Seite 34

EN
LCD
Description
Display
The auto-parking icon blinks on
the LCD.
Brake pedal icon shows on the
LCD
Seat sensor icon shows on the
LCD
PTO Switch icon blinks
Energy regeneration icon blinks
occasionally.
CCS icon blinks
OFF Charging Port Fault
FAULT CODE REFERENCE
Description
Left blade motor fails in rotation
Right blade motor fails in rotation
NOTICE: For any other fault codes appeared on the LCD screen, which may indicate PCBA failure, loosen connection, motor failure of the driving
motor, blade motors, etc., please remove all battery packs and re-insert them a few minutes later to restart the mower. If this doesn't solve the
problem, please record the fault code and contact EGO customer service center for repair.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
34
ZERO TURN RIDE-ON MOWER — ZT4200E-S
Mower
Status Beeper Cause
Indicator
The mower is parked on
a slope and the operator
Keeps leaves the mower without
OFF
beeping setting the parking-brake
pedal at the braking
position.
The parking brake pedal is
OFF No
set at the braking position.
The operator leaves the
seat or the seat safety
OFF No
interlock system is
disconnected.
The blade motor was
interrupted in operation
OFF No
and the PTO switch is not
set to off position.
The kinetic energy
generated during braking
OFF No or driving downhill is
converted into electricity to
charge the battery packs.
The CCS (cruise control
OFF No
system) function has failed.
Solid RED n/a There is no power supply.
Electronic faults, such as
the charging port is in open
Solid RED n/a
circuit, the fuse is blown,
etc.
Fault Code on LCD Audio Indicator
509 One beep
609 One beep
Solution
Set the brake pedal at the braking
position. The auto-parking icon will turn
off and the sound indicator will stop
beeping.
Release it before starting the mower.
If with the operator is seated on the seat
and the icon is on, stop operating the
mower immediately and check the seat
connection. If the seat connection with
the mower is confirmed correct, please
contact a qualified service technician for
repairs.
Before restarting the mower, push
the PTO switch down to turn off
the blade motors. Please see
"TROUBLESHOOTING" section in this
manual for reference.
This is normal operation. No action is
needed.
The CCS function could not be set when
the mower is driving at very low speed or
is driving in reverse.
Check the wall outlet whether there is
220V-240V supplied or the socket is
good.
Contact EGO customer service center for
repair.
Solution
Inspect the blade first. If it is loosened, tighten the bolt
with recommended torque. Otherwise, Please contact EGO
customer service center for repair.