Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
WARNING: Before commissioning the
appliance, the system must be tested to as-
sess the operating conditions of every sin-
gle component and detect any anomalies .
In this stage, it is important to check that all
health and safety requirements are strictly
adhered to .
To test the system, make the following checks:
Turn on the water supply tap and make sure
1)
that the connection is watertight.
INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS
The appliance's main functions do not requi-
re any special adjustments by specialist staff
except the settings made during use by the user.
INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
The appliance does not require the replacement
of operating components by specialist staff
except the replacement of standard parts which
can be carried out by the user.
EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL
NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during decom-
missioning.
When decommissioning the appliance, a set of
procedures should be carried out to ensure that
the appliance and its components are not a hin-
drance and are not easily accessible.
To ensure that the appliance cannot constitu-
te hazards for people or the environment, all
energy sources (electricity, etc.) must be discon-
nected and rendered unusable, and any liquids
present must be drained (lubricants, fluids, etc.).
12
TESTING OF THE APPLIANCE
ADJUSTMENTS
REPLACING PARTS
Check that the mains voltage is the same as
2)
that of the appliance.
Operate the appliance's circuit-breaker to
3)
check the electrical connection.
Check that the safety device is operating cor-
4)
rectly.
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance
into operation in conditions of safety, in ac-
cordance with legal requirements.
Place the appliance in a suitable area which is
not easily accessible, with barriers to prevent an-
yone from accessing it.
When scrapping, sort all components by chemi-
cal characteristics and dispose of them separa-
tely in accordance with the relevant legal requi-
rements.
IMPORTANT: Never dump non-bio-
degradable materials, lubricating oils and
non-ferrous metal components (rubber, PVC,
etc .) in the environment . Dispose of them in
accordance with the applicable laws .
ADJUSTMENTS
3320040_inst_GB_rev.3
Werbung
