Mounting The Rack To The Bicycle - Burley Dash Rm+ Bedienungsanleitung

Mounting the Rack to a Bicycle
1
First, fasten the bracket into the threaded
mounting points on the bicycle by the axle at
A, then fasten the stay rods B to the threaded
mounting points below the seat on the bicycle.
Lastly, assemble the stay block screws at c.
2
Ensure top of rack is level. If the stays extend
above the top of the rack, or interfere with
the wheel, the stays will need to be cut to
the proper length to fit your bicycle.
Mark the desired length of stay, remove from
rack and cut to the marked length. Ensure the
stay will be below the top surface of the rack
and at least a half inch beyond the stay block d.
3
tighten all bolts to a torque of
4 to 5 nm (3–3.7 ft-lb).
replace the rubber end caps once the
stays have been cut to length.
note
depending on your bike, your bike may require use
of the included spacers. use the appropriate spacer
and bolt combination to attach the rack.
8
ASSEMBLY & uSE
C
A
Optional
Spacers
ENG DEU FRA
C
D
B
ESP BURLEY.COM