Scheppach Airforce 7 Originalbetriebsanleitung Seite 27

• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards).
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
14. Troubleshooting
Fault
The compressor does not
start.
The compressor starts but
there is no pressure.
Compressor running,
pressure shown on the
display, but tools are not
running.
Possible cause
Mains voltage not present.
Mains voltage too low.
Outdoor temperature too low.
Motor is overheated.
Non-return valve leaking.
The seals are damaged.
Hose connections leaking.
www.scheppach.com
• If the manufacturer delivers a new electrical device
to a private household, the manufacturer can ar-
range for the free collection of the old electrical de-
vice upon request from the end user. Please contact
the manufacturer's customer service for this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
Check cable, mains plug, fuse and socket.
Avoid extension cables that are too long. Use
extension cables with sufficient conductor
cross-section.
Do not operate at outside temperatures below
+5°C.
Allow the motor to cool down.
If necessary, remedy the cause of the
overheating.
Replace the non-return valve.
Check the seals and have any damaged seals
replaced by a service centre.
Check compressed air hose and tools, replace
if necessary.
GB | 27