Scheppach Airforce 7 Originalbetriebsanleitung Seite 26

Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
12. Cleaning, maintenance and storage
m Attention!
Pull out the mains plug before carrying out any cleaning
or maintenance work! Danger of injury due to electric
shocks!
m Attention!
Wait until the device has cooled down completely! Dan-
ger of burns!
m Attention!
Depressurise the device before carrying out any clean-
ing or maintenance work! Danger of injury!
12.1 Cleaning
• Keep the device as free of dust and dirt as possible.
Rub the device clean with a clean cloth or blow it off
with compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior.
• The hose and injection tools must be disconnected
from the compressor before cleaning. The com-
pressor must not be cleaned with water, solvents or
similar.
12.2 Storage (Fig. 3-6)
m Attention! Pull out the mains plug. Store the
compressor in such a way that it cannot be used
by unauthorised persons.
m Attention!
Store the compressor only in dry locations that
are inaccessible for unauthorised persons.
• The mains cable (12) can be stowed on the holder
(4) on the right side.
26 | GB
• The compressed air hose (13) can be stowed on the
holder (1) on the left side.
• The adapter for tyre valves (8), the conical adapter
(7) and the ball needle (9) can be stowed in the stor-
age compartment (14).
• The tyre inflater (10) and the air blow gun (11) can be
attached to the holders (5, 6).
12.3 Transport (Fig. 1)
The unit can be transported with the handle (2).
12.4 Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Belts and couplers
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
13. Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act (ElektroG)
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are
not installed permanently in the old device must be
removed non-destructively before disposal! Their
disposal is regulated by the battery act.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.