Issue
The display needle
jumps to the highest value
of the display scale
The display needle is
always jumping to highest
value of the display scale .
The display needle cannot
be aligned with the middle
part of the display scale .
6 . Point the satellite antenna in a rough direction towards the desired satellite .
NOTE: Read the instruction manual of the satellite antenna or perform research
on correct values for the height and side angle required for adjusting the satellite
antenna .
7 . Rotate the control knob
part of the display scale
acoustic signal, the better the antenna is aligned towards the satellite .
Potential cause
The receiver signal is too
[
6 ]
high for the product .
.
1 ]
[
The connected LNB is
a high capacity type
with high amplification
(> 60 dB) ./The connected
satellite antenna is larger
than 1 metre .
until the display needle
[
3 ]
. The buzzer
1 ]
[
Solution
Reduce the sensitivity
of the product: Turn
the control knob
counter‑clockwise until the
display needle is aligned
with the middle part of the
display scale .
Insert an attenuation
controller (0 – 20 dB)
between the LNB and the
product .
is aligned with the middle
[
6 ]
emits an acoustic signal . The higher the
[
7 ]
3 ]
[
GB/IE
31