cecotec CREMMAET TOUCH OCS Bedienungsanleitung Seite 48

ENGLISH
3. OPERATION
3.1 Parts description
Following the enumeration in the parts and components section:
1. Water tank: always use bottled mineral water or filtered water.
2. Power switch: it is at the back of the coffee machine.
Power cable
3.
4. Drip tray: collects waste water and coffee grounds. Clean and empty the grounds when
the appliance requires it or when the machine is not to be used for a long period of time.
Coffee waste tank, consisting of:
5.
- Coffee bean hopper: only fill it with natural roasted coffee beans. Do not use blended
coffee or roasted coffee. Do not put any other product into the hopper. The hopper has a
mesh to improve the distribution of the coffee. The grinding level knob is located on the top
left-hand side of the hopper.
- Grinding level knob: located inside the bean hopper, the higher the grind number you
choose, the coarser the ground coffee will be. Turning the knob clockwise will increase the
size of the ground coffee. Turning the knob counterclockwise will decrease the size of the
ground coffee.
- Coffee powder inlet/cleaning tablets: only for single-use coffee powder (not a coffee
powder container) and cleaning tablets for cleaning the brewing system. To access this
part, you must open a tab with slots.
Button/indicator light: It is used to switch on/off the coffee machine, and to indicate the
6.
state in which the appliance is (on/off or standby mode).
7" touch display.
7.
8. Coffee spout: adjustable between 8 and 14 cm.
9. The spout is fitted with a device called "Cappuccinatore", which is removed by pressing the
two release tabs on the sides to facilitate cleaning. This part is responsible for expelling
coffee, milk, and water.
10. Fig. 3. The cappuccinatore is made up of 4 parts, the largest part where the steam comes
out to froth the milk has a small knob to select the amount of steam you want. For highly
steamed milk, turn the knob clockwise.
Milk tank: only fill it with cold whole milk to improve the milk froth result. Clean it after each
11.
use with water following the milk system quick clean.
3.2 Using the coffee machine for the first time
Plug in the coffee machine: Pull out the power cable and connect it to the mains.
1.
2. Fill the coffee bean tank. Open the tank cover, fill it with coffee beans and put the cover
back in place.
NOTE: only fill it with natural roasted coffee beans. Do not use blended or roasted coffee.
3.
Do not put any other product into the hopper.
Fill up the water tank. First, take it out and clean it. Then, put in bottled or filtered water,
4.
never exceed the MAX mark. Next, place it back in the appliance.
48
CREMMAET TOUCH OCS