Scheppach hs 120 o Originalanleitung Seite 41

Concealed cutting, rebating, Fig. E
Tool: Circular sawblade for fine cutting
Operating cycle: When performing rebating work at the
fence rail, select the cutting sequence which ensures
that the cut-off strip falls onto the side of the sawblade
or swing the suction hood up and lower the riving knife to
perform concealed cutting or rebating work. Ensure that
Electrical Connection
The electric motor is connected in a ready-to-operate
and DIN regulations.
The mains connection at the customer's work place and
the extension cable used must correspond to these regu-
lations.
Important information
The motor automatically switches off if it is overloaded.
The motor can be switched on again after a cooling-down
Faulty electrical connecting leads
Insulation damage often occurs at electrical connecting
leads.
Causes include:
through windows or the cracks of doors.
of the connecting leads.
lead.
connecting lead from the wall socket.
Faulty electrical connecting leads such as these may not
be used and are highly dangerous due to the insulation
damage.
Check electrical connecting leads regularly for damage.
Ensure that the connecting lead is not attached to the
mains supply when you are checking it.
Electrical connecting leads must correspond to the rele-
printed on the connecting lead by regulation.
Single-phase motor
Uszkodzenie przewodów elektrycznych
41