Ossur FORMFIT WALKER Gebrauchsanweisung Seite 6

• In high altitude conditions, the air chamber will expand past its
optimal level. Deflate air chamber to reduce compression to
a comfortable level.
GENERAL SAFETY INSTRUCTIONS
The healthcare professional should inform the patient about everything in
this document that is required for safe use of this device.
Any serious incident in relation to the device must be reported to the
manufacturer and relevant authorities.
The patient should immediately contact a healthcare professional:
• If there is a change or loss in device functionality, or if the device
shows signs of damage or wear hindering its normal functions.
• If any pain, skin irritation, excessive pressure, or unusual reaction
occurs with the use of the device.
The device is for single patient – multiple use.
FITTING INSTRUCTIONS
1. Unfasten straps and remove liner from walker (Fig. 1). Do not remove
pull tabs yet.
2. Place lower leg and foot into the liner and close following the order
shown (Fig. 2).
3. Insert foot into walker (Fig. 3). Ensure that the heel is fully seated in
the shell and that the struts are centered over the ankle bone. The foot
should be 90° to the lower leg. There should not be a gap between the
heel and shell (Fig. 4).
4. Place additional pads as needed to accommodate for rubbing and
spacing from the liner, shell, or straps (Fig. 5).
5. Pull release tabs on both sides on the shell to attach to the liner
(Fig. 6) and fasten straps as shown (Fig. 7).
6. Air versions only: turn the valve clockwise and press the air bladder
until the desired inflation is achieved (Fig. 8, 9).
7. Remove the walker by unfastening the straps and opening the liner.
Air versions only: turn the valve counterclockwise to deflate the liner
before doffing.
Accessories and Replacement Parts
Please refer to the Össur catalog for a list of available replacement parts
or accessories.
USAGE
Cleaning and care
Device plastic can be washed with a damp cloth and mild soap.
Remove liner from the device before washing.
• Hand-wash using mild detergent and rinse thoroughly.
• Air dry.
Note: Do not machine-wash, tumble dry, iron, bleach, or wash with fabric
softener.
Note: Avoid contact with salt water or chlorinated water. In case of
contact, rinse with fresh water and air dry.
DISPOSAL
The device and packaging must be disposed of in accordance with
respective local or national environmental regulations.
6