Principle Of Dynamic Stimulation - schwa-medico 101707 Gebrauchsanweisung

46
Electrode Positions for dynamic Stimulation
Sideways
Kanal 1 Kanal 2
Channel 1 Channel 2 Channel
Sideways wave:
E.g gluteus, stomach muscles
Kanal 1
Kanal 2
Kanal 3
Kanal 4
schwa-medico OPErATING MANuAL - EMP 4 ECO+

Principle of Dynamic Stimulation

The dynamic stimulation principle is based on the fact that the
stimulation is not applied simultaneously on all channels. Dynamic
stimulation generates a wave movement of the stimulation impulse
which moves to and fro between the electrode pairs and therefore
attains enhanced reproduction of the massaging effect. Dynamic
stimulation creates for the user a more pleasurable experience than
with classic neuro-muscular stimulation. The consecutive four channel
distribution of the electrical current produces good results in respect
of both pain alleviation and muscular relaxation. The application of
dynamic stimulation for lymph drainage accentuates the effect of the
wave type muscular contraction.
Kanal 3 Kanal 4
3 Channel 4
Kanal 4
Kanal 3
Dynamic stimulation on legs: Place one electrode of each channel
on each leg (size 5x9 cm). All anodes should be on one leg and all
Kanal 2
cathodes on the other leg.
Kanal 1
Dynamic stimulation on the back: Place one electrode of each channel
on each side of the spinal column (size 5x9 cm). Place all anodes on
one side and all cathodes on the other side.
Important note
If you use electrodes with two connectors, always connect them to the
same pole colour of the cables (either both blue or both red).
Kanal 1 Kanal 2 Kanal 3
Falling
Channel 1
Kanal 1
Kanal 2
Channel 2
Kanal 3
Channel 3
Kanal 4
Channel 4
Falling/Rising wave:
E.g. back, legs
Kanal 4
Rising
Channel
Kanal 4
Kanal 3
Channel
Kanal 2
Channel
Kanal 1
Channel
4
3
2
1