Werbung
Verfügbare Sprachen
Verfügbare Sprachen
fl owing back out of the pump. Use a higher auto-
start level accordingly.
Application 3:
The pump can be used in autostart mode where
the water level at the beginning is higher than the
preset autostart level. Regardless of the selected
autostart level, the pump will pump until 5 mm is
left and will then continue running on for a further
30 seconds before switching off automatically.
Please note:
The fact that it switches off automatically after 30
seconds will not prevent dry running! The water
can be sucked up down to a level of 1 mm as a
maximum.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
•
Unplug the power plug prior to any mainte-
nance work.
•
For mobile applications, the equipment
should be cleaned with clear water after every
usage.
•
For stationary installation, it is recommended
that you check the floating switch for proper
operation every three months.
•
Use a water jet to remove any lint or fibrous
particles that may have become trapped in
the housing.
•
Remove sludge from the shaft bottom and
clean the shaft walls every 3 months.
•
Use clear water to remove deposits from the
floating switch.
8.2 Cleaning the paddle wheel (Fig. 5/Item 2)
If a lot of deposits collect in the housing, the bot-
tom part of the equipment must be dismantled as
follows:
1. Detach the suction plate from the housing.
2. Clean the paddle wheel with clear water.
Caution! Do not put down or rest the equip-
Anl_GE-SP_4095_N-A_LL_ECO_SPK7.indb 17
Anl_GE-SP_4095_N-A_LL_ECO_SPK7.indb 17
GB
ment on the paddle wheel!
3. Assemble in reverse order.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
- 17 -
23.04.2024 10:35:58
23.04.2024 10:35:58
Werbung
