Kobra CYCLONE Betriebsanleitung Seite 30

ELECTRICAL INSTALLATION AND WIRING
IMPORTANT!
After the Cyclone has been connected to the power supply it may be
necessary to check the auto-shut off time by adjusting the "ALARM C"
knob as shown in the "Electrical Set-up and Tuning" section attached to
this operating instruction book (pag.77-82).
The adjustment of the "ALARM C" knob allows to adapt the shut-off
time of the Cyclone to the local voltage.
The "ALARM C" knob is already set at the factory but small differences
in the local voltage may require the adjustment of the shut off time
after shredding is completed.
KOBRA Cyclone 28 DI-129/13/14.04.2022