Preparation; Control Elements; Attaching And Removing The Saw Blade; Adjusting The Base Plate - Parkside Performance Pssap 20-Li D5 Originalbetriebsanleitung

GB MT
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.

Preparation

WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.

Control elements

Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• On/Off switch (5)
• Switching on: Press
• Continuously regulate the stroke
rate: The more you press the on/off
switch, the higher the stroke rate.
• Switching off: Release
• Switch lock (6)
• Unlocking: Press
• Locking: Release
Attaching and removing the
saw blade
CAUTION! Risk of injury
when touching the saw blade.
Wear protective gloves when at-
taching the saw blade.
30
Requirements
• The saw blade has a ½" universal
mount like the supplied saw blades
(17, 18).
• The saw blade is suitable for the re-
spective material.The scope of delivery
for the device includes a large-toothed
saw blade for wood and a fine-toothed
saw blade for metal and plastic.
• The chuck is free of splinters or other
material residue.
Installing the saw blade (Fig. B)
1. Turn the chuck (2) as far as possible ⭯
(seen from the front) and keep it fixed
in this position.
2. Place the saw blade (17, 18) into the
chuck (2).
3. Release the chuck (2).
4. Ensure that the saw blade (17, 18) is
correctly attached and that the teeth
point downwards.
Removing the saw blade (Fig. B)
1. Hold the saw blade (17, 18) firmly.
2. Turn the chuck (2) as far as possible ⭯
(seen from the front) and keep it fixed
in this position.
3. Remove the saw blade (17, 18) from
the chuck (2).
4. Release the chuck (2).

Adjusting the base plate

Notes
• Risk of injury! Remove the saw blade.
• Never use the device without the foot-
plate.
Procedure (Fig. A)
1. Unlock the footplate (1): Turn the lever
(14) downward.
2. Set the footplate (1) to the desired pos-
ition.
3. Lock the footplate (1): Turn the lever
(14) upward.