CONTROLS AND DISPLAYS
The VMF-RIC interface can be connected to the following controls for
fan coils and cold beams:
•
VMF-E19/E19I
•
T-TOUCH/T-TOUCH-I
•
MCR.
This interface can be used jointly with the VMF-IR remote control.
The VMF-IR remote control can be used to send all the commands
except the SWING functionality.
ATTENTION
To send the operating setpoint properly, the
:
operating season of the remote control must be set in the
same mode used by the thermostat at that time
The green LED blinks when the VMF-RIC receives a correct command.
The thermostat will work with the settings received (setpoint, operat-
ing mode, fan speed, etc...). The TIMER ON (turn on fan coil in x min-
utes) and TIMER OFF (switch off fan coil in x minutes) can be used indi-
vidually or in combination (see VMF-IR accessory instructions code
6795725) from the VMF-IR remote control.
The VMF-RIC user interface displays these functions by switching on
the green LED as indicated in the paragraph below.
Displays
The views described below relate to use of VMF-RIC with thermostats
designated for controlling the fan coils or cold beams.
OPERATING STATUS DISPLAYS
RED LED
Active with low brightness
Active with high brightness
Active with high brightness
Flashing (one flash every 300 ms)
Flashing (one flash every 300 ms)
Worn out
Worn out
Flashing (one flash every 300 ms)
BLUE LED
Worn out
Worn out
Flashing (one flash every 300 ms)
Worn out
Flashing (one flash every 300 ms)
Active with low brightness
Active with high brightness
Active with high brightness
LED DISPLAY
Heating operation in the absence of a request from
Heating operation in the absence of a request from
Hot operation with insufficient water
Operation in antifreeze with insufficient water
Cold operation in the absence of a request from the
Cold operation in the presence of a request from the
Cold operation with insufficient water
FUNCTIONING STATUS
the thermostat
the thermostat
Operation in antifreeze
thermostat
thermostat
A V M F R I C U J 2 3 1 1 5 5 8 0 2 0 0 _ 0 1
12