General Notes - WimTec PROOF S6 Montageanleitung Und Bedienungsanleitung

EN
PROOF S6

General notes

The "General installation
terms and conditions"
provided at
www.wimtec.com apply.
20 Shower control
Congratulations on purchasing the WimTec PROOF S4.
In order to ensure that you will be able to enjoy this high-quality
product for many years, please take note of the following cleaning
and maintenance recommendations:
Use mild cleaning agents containing soap
Do not use abrasive, scrubbing, sealing or acidic
cleaning agents or disinfectants
Clean the fitting with a soft sponge or cloth only
Do not use steam cleaners
This manual is valid for the following products:
WimTec PROOF S6:
Stainless steel
Chrome
WimTec PROOF S6 - thermal disinfection:
Stainless steel
Chrom
Delivery scope:
Front plate made out of staineless steel or chomed brass with
integrated electronics, mounting frame and thermostat knob with
hot-water barrier.
Important installation notes:
Mounting and installation may only be performed by a qualified
service provider in accordance with DIN 1988, ÖVE/ÖNORM E8001
and VDE 0100 Part 701. When planning and installing sanitary
facilities, all relevant local, national and inter-national standards and
provisions must be observed! Provide for 230 V / 12 V power unit
outside of the protected zone.
!
According to the Austrian ÖNORM B 5019, thermal disinfection
requires a minimum temperature of 60 °C for at least 10 min at the
relevant system locations. The operator must ensure that all parts of
the installation (e.g., piping) can withstand the temperatures applied
during thermal disinfection.
WimTec PROOF S6
Art.No. 118 940
Art.No. 118 957
Art.No. 118 964
Art.No. 118 971