WimTec PROOF S6 Montageanleitung Und Bedienungsanleitung Seite 27

PROOF S6
Assembly
12
15
12.Attach the mounting frame using the 4 screws. Make sure
that the cable connections remain intact and the cables are
not crimped.
13. Correctly align the mounting frame and securely fasten the
screws. When tightening the screws, ensure that the moun-
ting frame does not get warped. Apply the included special
grease to the front of the valve.
14.Check the thermostat position (turn the thermostat shaft to
the leftmost position, and then turn it to the right until the
arrow points upwards).
15. Connect the ON/OFF button to the electronics module.
16. Check the position of the mixer (safety button points
upwards).
13
16
Shower control
14
ATTENTION!
Perform the following steps
in the order indicated!
WimTec PROOF S6
EN
!
27