WimTec PROOF S6 Montageanleitung Und Bedienungsanleitung Seite 26

EN
PROOF S6
Assembly
7
10
7. Feed the 2 x 0.5 mm
and connect it to the power supply (art. no. 117 899 and art. no. 113 792).
Attention: The power supply must not be installed in the flush-mount set!
8. Connect the magnetic valves to the electronics module.
(red = therm. disinfection)
9. Connect the power cables to the electronics module.
Thermal disinfection:
A
ON/OFF button:
B
Infrared sensor: connection
C
10.
Configure the desired functions at the electronics module and insert the elect-
ronics module into the flush-mounted set.
11. Connect the power cables to the electronics module (mind correct +/- polarity)
and connect the grounding wire (yellow) to the water path. Switch on the
power supply (the safety lock mechanism of the magnetic valve will activate).
26 Shower control
8
11
power connection cable and into the flush-mount set
2
feed the control line
see step 16
with of the mounting frame
WimTec PROOF S6
9
A
B
C