hillvert HT-WB-650 Bedienungsanleitung Seite 41

To avoid implements seizing, it is necessary to grease the quick coupler daily.
While to mount the sickle bar, it is necessary to turn the handlebar of 180°. Before this, release the speed
shift lever and PTO lever from their supports, pull the handlebar steering column and turn it 180o. Insert it
again after choosing the ideal position of the handlebar. After turning the handlebar, levers must be
inserted again into the supports. When the handlebar is turned, the machine will go forward in reverse
speed and back in 1st speed.
Engine oil
OIL HAS BEEN DRAINED FOR SHIPPING. Failure to fill engine sump with oil before starting engine will
result in permanent damage and void engine warranty.
3.3. Device use
Adding fuel
Fill the fuel tank as instructed in the separate Engine Manual packed with the machine.
Starting the machine
1. Ensure that PTO lever is disengaged and speed shift lever is in idle position.
2. Set the throttle lever on the handlebar at halfway position. If the engine is cold, engage the choke on
the carburettor.
3. Set engine for starting as described in the engine manual.
4. Pull the starter grip lightly until you feel resistance, then pull briskly, return the starter grip gently. The
starter grip must always be grasped with one hand only, to prevent the engine "kicking back". When
the engine has started, allow it to run idle for some minutes to allow oil to lubricate all moving parts.
5. Engage and locate the speed shift lever to the desired position.
6. Connect PTO, Increase the speed as appropriate and squeeze the engine stop lever to start work.
Stopping the machine
Decelerate, disengage the PTO and speed shift levers to neutral position and fully release the engine stop
lever.
Tilling depth adjustment
Lower the depth regulator rod will slow the tiller and make it till deeper. Raising the depth regulator rod
will allow it to move faster and till shallower.
To adjust the tilling depth
1. Remove the fixing screw.
2. Raise or lower the depth regulator rod to the desired position.
3. Replace the fixing screw.
Sickle bar height adjustment
When working on bad terrain, it is necessary to adjust the mower's cut height in the following way.
1. Loosen nut.
2. Bring the skid pad back to wanted position.
3. Lock the nut again.
Mower blade holder adjustment
1. Loosen fixing screw.
2. Turn the adjustment screw.
3. Tighten the fixing screw again.
4. NOTE: excessive friction between the blade holder and the blade must be avoided in order to ensure
good function.
Mower blade replacement
1. Loosen screw.
2. Remove blade catch.
EN