Preparing The Product For Operation; Unpacking The Scope Of Supply; Keeping The Original Packaging; Setting Up The Appliance - Rowi HIT 2000/1 Q Basic Betriebsanleitung

2.

Preparing the Product for Operation

2.1

Unpacking the scope of supply

Check whether the scope of supply is complete and free of defects immediately after ope-
ning the packaging. Contact the seller immediately if the scope of supply is incomplete or
defective. Do not put the appliance into operation if it is defective.
2.2

Keeping the original packaging

Keep the original packaging in a safe place over the entire service life of the product. Use
the packaging for storing and transporting the appliance. Only dispose of the packaging
after the product service life has come to an end. You can find information on the proper
disposal in Chapter 7.
2.3

Setting up the appliance

Before the appliance can be put into operation, observe the following safety infor-
mation and follow the setup and installation instructions in Chapters 3.2.1 and 3.2.2:
P Only connect the appliance to the mains socket after complete assembly.
P Keep a minimum distance of 1 m to curtains and other flammable materials.
P Switch off the appliance and allow it to cool down before you adjust the angle of tilt.
P Do not cover the appliance!
P During assembly, make sure that the integrated thermostat is not affected, if possible,
by ambient conditions such as windows, room height etc.
P The power plug and thermostat rotary knob must be accessible at all times - irrespective
of the appliance setup (standing or wall mounting).
FIN_103030102_DE-GB_HIT 2000-1 W Basic.indd 28
28/40
EN
10.06.2014 10:12:48