cecotec CONGA 8490 ULTIMATE ULTRA POWER HOME Bedienungsanleitung Seite 72

ENGLISH
The robot
vacuum cleaner
makes a strange
noise during
operation
The robot
vacuum cleaner
does not clean
efficiently or
doesn't pick up
all the dirt
The robot
vacuum cleaner
could not
connect to the
Wi-Fi network
The robot
vacuum cleaner
did not carry out
the scheduled
cleaning task
The robot
vacuum cleaner
does not return
to the self-
emptying base
after finishing
Spot cleaning
or changing the
starting position
72
The main brush, side brush, or omnidirectional wheel are blocked or
tangled. Stop the robot vacuum cleaner and clean them.
The tank is full. Empty it and clear the high-efficiency filter if it is
blocked.
The high-efficiency filter is blocked. Clean it.
The main brush is blocked or tangled. Clean it.
Bad Wi-Fi signal. Check that the robot vacuum cleaner is located in an
area with good Wi-Fi signal.
The Wi-Fi connection is unstable. Reset the router, check if there
are any App updates, and try again. This robot vacuum cleaner only
supports the 2.4 GHz band.
Make sure that your smartphone mobile data are disabled to improve
the linking process.
Check if the robot vacuum cleaner is in Sleep mode and change mode.
This option can be found on the general settings of the robot vacuum
cleaner and allows you to define time slots in which the robot will not
perform the scheduled cleaning tasks when in Sleep mode.
Ensure proper connection of the robot vacuum cleaner to the
Wi-Fi: you will not be able to carry out scheduled cleaning without
connection and with a low battery.
The robot vacuum cleaner will map and calculate a new route after
running in Spot cleaning mode or after changing its starting position.
If the self-emptying base is too far away from the robot vacuum
cleaner, the latter won't be able to return to the base. Manually move
the robot vacuum cleaner close to the self-emptying base.