cecotec CONGA 8490 ULTIMATE ULTRA POWER HOME Bedienungsanleitung Seite 71

Changing the dirt-disposal bag. Fig. 16
Open the top cover, remove the bag by carefully pulling it upwards, and replace it with a new
one.
Charging and replacing the battery
- To extend battery life, leave the robot vacuum cleaner charging on the self-emptying base
whenever not in use.
- Remove the battery and store it in a safe, dry place if the robot vacuum cleaner will not be
used for a long period of time.
- To replace the battery, follow the instructions below:
- Unscrew the screws on the lower housing, remove the latter, and take out the battery.
- Insert the new battery.
- Put the battery and the lower housing back in place and re-tighten the screws.
5. TROUBLESHOOTING
Robot vacuum cleaner
Problem
The robot
vacuum cleaner
does not switch
on or does not
clean
The robot
vacuum cleaner
isn't charging or
returning to the
self-emptying
base
The robot
vacuum cleaner
does not work
properly
Possible cause and solution
The robot vacuum cleaner does not work when battery is low. Allow it
to charge before operation.
The room temperature is below 0 °C or above 40 °C.
There are too many obstacles near the self-emptying base. Relocate
the base to an obstacle-free area.
Clean the charging terminals of the robot vacuum cleaner and the
self-emptying base.
Make sure the robot vacuum cleaner is switched on.
The robot vacuum cleaner is too far away from the self-emptying
base. Place it closer and try again.
Turn off the robot vacuum cleaner and turn it on again.
Reset the robot vacuum cleaner by pressing the side Reset button.
CONGA 8490 ULTIMATE ULTRA POWER HOME
ENGLISH
71