cecotec CONGA 8490 ULTIMATE ULTRA POWER HOME Bedienungsanleitung Seite 63

Note:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This robot vacuum cleaner includes a package designed to protect it during transport.
Take the robot vacuum cleaner out of the box. Keep the original box and other elements
in a safe place, as this will help you prevent damage to the robot vacuum cleaner when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, contact the official Cecotec Technical Support
Service immediately.
Warnings
- Remove all objects around the robot vacuum cleaner such as clothing, papers, cables,
curtains, or other fragile objects which may block or slow down the operation of the robot
vacuum cleaner. Fig. 4
- If the room to be cleaned is near a balcony or stairs, a physical barrier should be placed to
prevent the robot vacuum cleaner from falling and getting damaged, thus ensuring safe
operation. Fig. 5.
- Do not use the robot vacuum cleaner to vacuum up liquids. Fig. 6.
- Direct exposure to sunlight or heavy light contrasts may affect the correct operation of the
sensors. If this happens, the robot vacuum cleaner will cease operation. Move it to a new
location for it to start operating again.
- Please note that the total height of the robot vacuum cleaner is 9,5 cm and the sensors
are at the bottom, so it is advisable to prevent access to all areas below 9,5 cm to avoid
damaging the laser.
Installing the robot vacuum cleaner and the self-emptying base
1. Place the self-emptying base against a wall and leave a minimum free space of 1.5 metres
to the front and 0.5 metres to each side. Fig. 7
2. Plug the self-emptying base to a power socket. Wind and store the remaining cable to
prevent accidents.
3. Press and hold the Start/Pause button for a few seconds.
4. When the indicator light turns on, put the robot vacuum cleaner in the self-emptying
base and make sure the charging terminals of the robot match those of the base. If the
indicator light is flashing blue, it means the battery is not completely charged. To ensure
the maximum cleaning time, wait until the light turns into steady blue, as this indicates
that the battery is fully charged and that the robot vacuum cleaner is ready to clean. Fig. 8
CONGA 8490 ULTIMATE ULTRA POWER HOME
ENGLISH
63