Werbung
Operating the Fire
Manual Controls.
The Opti-myst Manual controls are located behind the drawer front. Slide out the drawer to access the controls. (See
Fig. 2 for Manual Control lay out)
Switch 'A':- Controls the electricity supply to the heater.
Note: This switch must be in the 'ON' ( I ) position for the heater to operate with or without heat.
Switch 'B':- Controls the function of the fire.
Press
once to turn on flame effect. This will be indicated by one beep.
Although the main lights operate immediately it will take a further 30 seconds before the flame effect starts.
Press it again to give flame effect and heat. This will be indicated by two beeps.
Press it again to return to flame effect only.
This will be indicated by one beep.
Press
to put fire in to standby mode.
This will be indicated by one beep.
Switch 'C':- Controls the mist extractor motor.
There are two speeds for the mist extractor motor, low and high. This function is required to eliminate concensation on
the glass. When the unit is switched on the mist extractor motor will run at high speed for 1 minute and then will default
to the switch setting.
Thumb Wheel 'D':- Controls the mist output.
Pressing the wheel up will increase the ammount of mist produced and pressing the wheel down decreaces the ammount
of mist produced.
Note: Should condendsation occure on the glass, simply turn down the mist and switch the mist estractor motor to high
speed until the concensation has been eliminated.
When the water is empty the main lamps go out. See instructions under 'Maintenance', 'Filling the water tank'. When this
procedure is complete, the main lamps will illuminate but it will take 30 seconds before the flames return.
Remote Control Operation
On the control panel, Switch A (see Fig. 2) must be in the 'ON' ( I ) position in order for the remote control to operate. There
are 3 buttons on the remote control. (See Fig. 7)
To operate correctly the remote must be pointed towards the front fuel effect.
The remote control functions are as follows:
Press once to turn on Flame effect only.
This will be indicated by one beep.
Press once to turn on Heat and Flame effect.
This will be indicated by two beeps.
Standby
This will be indicated by one beep.
Battery Information.
1. Unclip the battery cover on the back of the remote control. (See Fig. 7)
2. Install AAA batteries into the remote control.
3. Replace the battery cover.
Discard leaky batteries.
Dispose of batteries in the proper manner according to provincial and local regulations.
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all the batteries are
not replaced at the same time, if disposed of in a fire, or if an attempt is made to charge a battery not intended to be
recharged.
Thermal safety cut-out
A thermal safety cut-out is incorporated in the fan heater to prevent damage due to overheating. This can happen if the
heat outlet was restricted in any way or if the chimney flue has not been blocked off effectively. If the cut-out operates,
unplug the heater from the socket outlet and allow approximately 10 minutes before reconnecting. Before switching the
heater back on remove any obstruction that may be restricting the heat outlet, then continue normal operation.
Caution: In order to avoid hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied
22
Werbung
