Refco VAMP-F Bedienungsanleitung Seite 6

8.2 Tools needed
8.3 Install Posable Hose
Disconnect flexible drain hose from the drain pan outlet.
Push the posable hose onto the drain pan outlet and secure in place
with a zip tie.
Filter
near
drain
Instruction Manual
8.4 Connect Pump to Posable Hose
Place the pump at a suitable location within the line-set cavity of the
indoor unit, such that it is possible to connect the pump's water inlet
to the posable hose.
Push the free end of the posable hose onto the water inlet of the
pump, and secure in place with a zip tie.
You must ensure that the pump is upright, such that the vent hose
nozzle is facing upwards, to ensure correct operation of the pump.
8.5 Vent Tube
Push the supplied vent tube onto the nozzle, as shown. Make sure
that the top of the tube is higher than the water in the posable hose
and the drain pan will be. If necessary, secure the vent tube to
ensure that it does not move when the product is in use. Operating
the pump without vent tube installed is not recommended.
Instruction Manual