When working with the machine, always hold it firm-
□
ly with both hands and provide for a secure stance.
The power tool is guided more secure with both
hands.
Secure the workpiece. A workpiece clamped with
□
clamping devices or in a vice is held more secure
than by hand.
Wear a dust mask.
□
ADDITIONAL SAFETY AND WORKING INSTRUC-
TIONS
WARNING ≥ 16 kg
Do not overreach. Keep proper footing and balance
□
at all times.
Use protective equipment. Always wear safety
□
glasses when working with the machine. The use
of protective clothing is recommended, such as dust
mask, protective gloves, sturdy non-slip footwear
and ear defenders.
The dust produced when using this tool may be
□
harmful to health. Do not inhale the dust. Use a dust
absorption system and wear a suitable dust protec-
tion mask. Remove deposited dust thoroughly, e.g.
with a vacuum cleaner.
Always keep the connection cable from the working
□
area of the device. Always guide the cable back-
wards, away from the device!
Do not machine any materials that present a danger
□
to health (e.g. asbestos).
When working in walls ceiling, or floor, take care to
□
avoid electric cables and gas or waterpipes.
Please turn the device immediately off when the
□
tool used gets blocked! Do not turn the device on
again when the tool is still blocked. This could cause
bounce back with a high reaction moment. Deter-
mine and remove the cause of the blocking of the
tool used while respecting the safety instructions.
The possible causes may be:
it is tilted in the workpiece to be machined
•
it has pierced through the material to be machined
•
the power tool is overloaded
•
Do not reach into the machine while it is running.
□
Chips and splinters must not be removed while the
□
machine is running.
WARNING! Danger of burns
The insertion tool may become hot during use.
when changing tools
•
when setting the device down
•
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Technical data
Blow rate min
:
-1
Dimensions L x W x H mm:
Blowing force Joule:
Weight kg:
Motor V/Hz:
Power consumption P1 W:
Protection class:
Type of Protection:
Tool fitting:
Technical modifications subject to change!
Sound and vibration
Sound and vibration values were measured in accord-
ance with EN 60745.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA(guaranteed)
Uncertainty K
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Chiseling
Main handle:
Vibration emission value a
Uncertainty K = 1,5 m/s
Auxiliary handle:
Vibration emission value a
Uncertainty K = 1,5 m/s
Additional information for electric power tools
Warning!
The specified vibration value was established in ac-
cordance with a standardized testing method. It may
change according to how the electric equipment is
used and may exceed the specified value in excep-
tional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
652 x 157 x 276
230 V~ / 50 Hz
SDS-HEX-System 30 mm
98,6 dB(A)
105 dB(A)
= 18,2 m/s
2
h, Cheq
2
= 14,5 m/s
2
h, Cheq
2
GB
19
2000
50
16
1600
II
IP20
0,7 dB
0,7 dB