Scheppach AB1600 Originalbetriebsanleitung Seite 16

Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschine GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
Note: According to the applicable product liability laws,
the manufacturer of the device does not assume liabil-
ity for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113.
WE RECOMMEND:
Read through the complete text in the operating in-
structions before installing and commissioning the de-
vice. The operating instructions are intended to help
the user to become familiar with the machine and take
advantage of its application possibilities in accordance
with the recommendations. The operating instructions
contain important information on how to operate the
machine safely, professionally and economically, how
to avoid danger, costly repairs, reduce downtimes and
how to increase reliability and service life of the ma-
chine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regu-
lations that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
16 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
In addition to the safety notes contained in the present
operating instructions and the special regulations of
your country, the generally recognized technical rules
for the operation of machines must be observed.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.
Device description (Fig.1)
1 Motor housing
2 Handle
3 ON- / OFF switch
4 Additional handle
5 Tool holder
6 Locking bolt
7 Oil fill opening / sight glass
8 Point chisel
Scope of delivery (Fig.1.1)
Demolition Hammer (1x)
Transport box (1x)
Point-chisel ø 30 L390 (1x) (C)
Flat-chisel ø 30 L390 (1x) (D)
Oil can (1x) (G)
Maintenance-tool (1x) (F)
Replacement-Motor~/Carbon brush (2x) (E)
Instruction manual (1x)
• Open the packaging and remove the device careful-
ly.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage. When complaints the dealer must be in-
formed immediately. Subsequent complaints will not
be accepted.
• If possible, store the packaging until the warranty
period has expired.
• Read the operating instructions to make yourself fa-
miliar with the device prior to using it.