Parkside Performance PPBSA 20-Li A1 Originalbetriebsanleitung Seite 14

IE
Removing the auxiliary handle
1. Turn the handle (20) of the auxiliary
handle (21) in an anticlockwise direc-
tion.
2. Press the handle (20) towards the ex-
tension (19) and hold it in position.
3. Remove the auxiliary handle (21) from
the device by pulling the loop (17) on
the auxiliary handle (21) over the drill
chuck (2).
With the butterfly screw (18), you
can fix a depth stop (optionally avai-
lable, see section "Spare parts/accesso-
ries").
Switching on/off
By using the on/off switch (16) you can
progressively control the speed. The longer
you push the on-off button, the higher the
speed.
With the gear selection switch (5) you
preselect a speed, see the section "Gear
selection". With the slip clutch selection
switch (4), you can choose the drilling
screw
operating mode, see the section
"Switching the slip clutch on/off". We
recommend running the screw operating
mode in 1st gear.
1. Press the on/off switch (16) to start the
device. The LED work light (14) lights
up during operation and approximately
10 seconds after you release the On/
Off switch (16).
The lighting duration of the LED
work light (14) can be set in the
Lidl Home App, see section "Connec-
ting the device with the Lidl Home App
> App functions".
2. To turn it off, release the on/off
switch (16). When you move the direc-
tion switch (6) to the middle position,
14
the device is secured against being
switched on.
During breaks in work, the device
can be hung from a belt, using the
integral metal clip (9). Take care to
ensure that the device is switched
off and secured against accidental
activation.
The metal clip is also suitable for
opening bottles with bottle caps.
Connecting the device
with the Lidl Home App
The device can only be connected to
the Lidl Home App if you are using it
with a Smart Performance battery.
Upgrading the firmware can change
the features of the app.
1. Slide the device base onto a Smart Per-
formance battery until it clicks into pla-
ce. Briefly press the On/Off switch (16).
or
The smart app LED
next to the LED work light (14)
lights up.
2. Enable Bluetooth
3. Open the Lidl Home App.
From here there are options

and to connect the device.
 If this is the first device you want to con-
nect to the app:
4. On the tab
tion "Add device".
The app scans the area for available de-
vices and indicates if available devices
have been found.
If this is not the case, read on if
possible
(15)
® on your smartphone.
 
,
"At home", select the op-

.

,