Parkside PHPA 4 C4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 19

3 . Apply the glue in spots . For flexible materials, such as textiles, apply the glue in
zigzag lines .
4 . Press the two workpieces to be bonded together immediately after applying
the glue . Hold for approx . 30 seconds . The glued bond is ready after approx .
5 minutes .
Insert a new glue stick
o
totally drawn into the feeder shaft .
During breaks in work, keep the product in standing position so that the product is
standing on its base
NOTE
Some materials may be damaged by exposure to heat . Test on scrap material .
u
Remove any glue residue after it has cooled down with a sharp knife . Bonded
u
joints can be released by heating .
Large areas are difficult to bond . The adhesive will harden before you have
u
extruded the right amount .
˜ Switching off
Switching off the product: Press the on/off button
o
indicator and the LED work light
[ 8 ]
During breaks in work, keep the product in standing position so that the product is
standing on its base
Before storing the product: Allow the product to cool down fully .
m WARNING!
The hot nozzle
u
into the feeder shaft
[ 4 ]
.
6 ] [
.
6 ] [
can cause damage and/or burns .
1 ] [
, when the old glue stick is
3 ] [
. The battery status
7 ] [
switch off .
9 ] [
GB 19