Installing The Expansion Module For The User Module - G&D DVI-FiberLink Installationsanleitung

Installation

Installing the expansion module for the user module

Place the second expansion module close to the user module to be connected.
Use a CAT5 (or better) twisted pair cable to connect this interface to
Transmission CAT:
the interface of the user module.
Transmission
Transmission – Tx: Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the
receiver module.
Transmission – Rx: Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the
receiver module.
Power In: Connect the external power pack or the power loop cable, which is connected
to another expansion module, to this interface.
If the external power pack is to supply power to another expansion mod-
Power Loop:
ule, connect an optional power loop cable to this interface.
NOTE: Detailed information regarding the power supply with power loop cables is
given on page 14.
13 · DVI-FiberLink
Transmission – Rx
Transmission – Tx
interface of the
interface of the