Herunterladen Inhalt Inhalt Diese Seite drucken

Installing The Expansion Module For The Target Module - G&D DVI-FiberLink Installationsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Installing the expansion module for the target module

Place the second expansion module close to the target module to be connected.
Transmission CAT:
Use a CAT5 (or better) twisted pair cable to connect this interface to
the
Trans.
interface of the target module.
Transmission – Tx:
Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the
receiver module.
Transmission – Rx:
Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the
receiver module.
Power In:
Connect the external power pack or the power loop cable, which is connected
to another expansion module, to this interface.
Power Loop:
If the external power pack is to supply power to another expansion mod-
ule, connect an optional power loop cable to this interface.
NOTE:
Detailed information regarding the power supply with power loop cables is
given on page 14.
Transmission – Rx
interface of the
interface of the
Transmission – Tx
DVI-FiberLink · 10
Installation

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis