Installation
Installing an expansion module for the slave matrix switch
Place the second expansion module close to the slave matrix switch component to
be connected.
Use a CAT5 (or better) twisted pair cable to connect this interface to
Transmission CAT:
a
in the
Dynamic Port
Insert the LC plug of the fibre optics, which is available as acces-
Transmission – Tx:
sory. Connect the other end of the cable to the
receiver module.
Transmission – Rx:
Insert the LC plug of the fibre optics, which is available as acces-
sory. Connect the other end of the cable to the
receiver module.
Power In:
Connect the external power pack or the power loop cable, which is connected
to another expansion module, to this interface.
Power Loop:
If the external power pack is to supply power to another expansion mod-
ule, connect an optional power loop cable to this interface.
NOTE:
Detailed information regarding the power supply with power loop cables is
given on page 14.
7 · DVI-FiberLink
mode of the slave matrix switch.
CON
Transmission – Rx
Transmission – Tx
interface of the
interface of the