Parkside PDSA 20-Li C2 Bedienungs- Und Sicherheitshinweise Seite 23

˜ 20 V battery pack ‒ charging
information
˜ Checking the battery pack
charging level
(Fig . H)
Check battery pack charge level: Press the
o
button . The charging level LEDs
[ 29 ]
light up:
LED
Red/yellow/green
Red/yellow
Red
˜ Charging the battery pack
(Fig . I)
NOTE
If the battery pack
u
battery to cool down completely before
charging .
The battery pack
u
any time without reducing the life .
Interrupting the charging process does not
u
damage the battery pack
Charge the battery pack
u
operation when it is at medium or low
charging level .
1 . The charging control LEDs (green
red ) indicate the status of the charger
32 ] [
and the battery pack
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
20 GB
28 ] [
Charging level
Maximum
Medium
Low
is warm: Allow the
21 ] [
may be charged at
[ 21 ]
.
[ 21 ]
before
21 ] [
and
[ 33 ]
:
21 ] [
Status
Battery pack charges
Battery pack fully
charged
Battery pack
defective
Battery pack too cold
or too warm
Charger ready
2 . Insert the battery pack
charger .
31 ] [
3 . Connect the mains cord with mains plug
of the charger
4 . When the battery pack
charged: Remove the battery pack from
the charger
plug of the charger from the mains
30 ] [
socket .
˜ 12 V battery pack ‒ charging
information
(Fig . J)
˜ Charging the battery pack
m WARNING!
Charge the battery pack
u
room only . Prior to inserting the battery
into the battery charger
outer surface of the battery pack is clean
and dry . There is a risk of injury due to
electric shock .
m CAUTION!
Do not expose the battery pack
u
extreme conditions such as heat or impact .
Risk of injury from escaping electrolytic
solution! After eye/skin contact, rinse the
affected areas with water or a neutraliser
and consult a doctor .
31 ] [
NOTE
The battery pack
u
capacity once it has been charged several
times .
Charge the battery pack
u
it for the first time .
Only use chargers from the
u
X 12 V TEAM series to recharge the
battery pack
into the
21 ] [
to the mains socket .
31 ] [
is fully
21 ] [
. Then disconnect the mains
[ 31 ]
in a dry
34 ] [
, check that the
36 ] [
[ 34 ]
only reaches its full
34 ] [
before using
[ 34 ]
.
[ 34 ]
[ 30 ]
to