Unpacking; Requirements On The Installation Location - Graef contessa Bedienungsanleitung

Unpacking

When unpacking the unit, proceed as follows:
Pull the unit out of the cardboard box.
●
Remove all packaging and possible stickers on the unit (do not remove
●
the name plate).

Requirements on the installation location

For safe and fault-free operation of the unit, the following has to observed
during installation:
Use a firm, even, horizontal, non-slip and heat resistant surface with a
●
sufficient load capacity.
Select an installation location in such a way that children cannot reach
●
any hot surfaces of the unit.
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
The power outlet must be easily accessible so that the power cable can be
●
quickly removed in case of emergency.
63
EN