Areas Of Use; Safety Checks - Stiga PARK MIRAGE 5.0 Gebrauchsanweisung

2.4.19 Cutting deck angle
The cutting deck has a basic setting where its rear
edge is 5 mm above its front edge. This means that
the deck is inclined forwards.
At the basic setting the two pins (9:E) are in the
second hole from the top.
When the cutting deck is inclined forwards, the
"mulching" effect is reduced while the cut grass is
dispersed better and the capacity is increased.
Forward inclination can be increased by moving
the two pins down one hole from the basic setting.
Greater forward inclination is recommended for
thicker grass.
2.4.20 Mulching/rear ejection
The deck can cut grass in two ways:
• Mulching, where the finely cut grass is spread
on the lawn. The mulching mode makes it easi-
er for the grass to compost in the lawn and it is
converted to fertiliser.
• Eject the grass behind the deck.
The deck is set for mulching on delivery. In order
to eject the grass behind the deck, the plug (8:D)
must be removed.
Set the deck in cleaning or service position in order
to remove/install the plug.

3 AREAS OF USE

The machine may only be used for the following
tasks using the genuine STIGA accessories stated.
Work Accessories, STIGA original
Mowing With the originally fitted cut-
ting deck.
Grass clipping and Using towed collector 30" or
leaf collection 42".
Grass and leaf With dump cart Pro or Combi.
transport
The maximum vertical load on the towing hitch
must not exceed 100 N.
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.
ENGLISH
4 STARTING AND OPERATION

4.1 Safety checks

Check that the results of the safety checks below
are met when testing the relevant machine.
The safety checks must always be car-
ried out before each use.
If any of the results below are not met,
the machine must not be used. Take the
machine to a service workshop for re-
pair.
4.1.1 General safety checks
Object
Power cables.
Batteries
Tyres
Continue with the following after the machine
has been activated .
Drive the machine
forwards/back-
wards and release
the drive/service
brake pedal.
Run the machine
forwards and press
the brake.
Test driving
4.1.2 Electric safety check
The safety system's function must al-
ways be checked before each use.
Status
The emergency
brake pedal not
depressed.
Machine activated. The operator
The cutting deck
running
The cutting deck
running
Result
All insulation intact.
No mechanical damage.
All insulation intact.
No mechanical damage.
All screws tightened.
No visible low tyre pressure.
The machine should stop.
The machine should stop.
No vibrations.
No unusual noise.
Action Result
Try to activate the The machine
machine. cannot be
activated.
The cutting
leaves the seat. deck must
stop within 5
seconds.
Switch off with the The rotation
button (1:G) must stop
within 5 sec-
onds.
Switch off by turn- The rotation
ing the key (1:E) must stop
to the stop posi- within 5 sec-
tion. onds.
GB
37