Residual Risks; Practical Tips; Scrubbing Wheels; Grinding With A Wire Brush - Parkside Performance Pwsap 20-Li E6 Originalbetriebsanleitung

GB MT
•­ Grinding­thin­sheets­or­other­slightly­
vibrating­structures­with­a­large­surface­
area can result in a much higher noise
emission­value­(up­to­15­dB)­than­the­
specified­emission­value.­Such­workpi-
eces­should­be­prevented­from­emitting­
noise as far as possible by suitable
measures,­such­as­the­use­of­heavy,­fle-
xible­damping­mats.­Take­this­increased­
noise emission into account in the risk
assessment and use adequate hearing
protection.

RESIDUAL RISKS

Even­if­properly­operating­and­handling­this­
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a)­ Lung­damage­if­suitable­respiratory­
protection is not worn.
b)­ Hearing­damage­if­suitable­ear­protec-
tion is not worn.
c)­ Damage­to­health­due­to­
-­ touching­the­area­of­the­grinding­tool­
which­is­not­covered;
-­ ejection­of­parts­of­workpieces­or­
damaged grinding discs.
d)­ Health­injuries­which­result­from­swin-
ging­hand­and­arm,­in­the­event­that­
the­device­is­used­over­a­longer­period­
of time or is not used and maintained
properly.
Warning! During operation, this
electric tool generates an electroma-
gnetic­field­which,­under­certain­
circumstances, may impair the functionality
of­active­or­passive­medical­implants.­To­
reduce the risk of serious or lethal injuries,
we recommend that persons with medical
implants consult their doctor and the ma-
nufacturer of their medical implant before
operating the machine.
42

Practical tips

When selecting the tool, en-
sure that its specified permis-
sible rotation speed is at
least as high as the maximum ro-
tation speed specified on the angle
grinder.
When selecting the disc, pay atten-
tion to the maximum permissible dia-
meter and the maximum permissible
thickness.
Pay attention to the thread size
M14 when selecting the brush.

Scrubbing wheels

never use a cutting wheel
for scrubbing !
The device must only be
operated with the protecti-
ve hood mounted when the
rough grinding wheel is used.
Fit­the­protective­cover­(7)­for­the­scrub-
bing wheels, see "Fitting/adjusting/remo-
ving­the­protective­cover".
Exert­only­moderate­pressure­on­the­workpi-
ece.­Move­the­device­evenly­back­and­forth.
A­working­angle­of­30°­to­40°­achieves­
the best results for scrub grinding.

Grinding with a wire brush

Ensure that you observe the
permissible speed when se-
lecting the wire brush. The
permissible rotation speed of the
wire brush must be at least as high
as the highest rotation speed indi-
cated on the angle grinder.