PeakTech 2801 Bedienungsanleitung Seite 36

6.4 Display Illumination
Press "Backlight"-button (10) and the backlight of the display can
be switched on or off, user can trigger the function when there is
a darkness situation. The value is clear visible on the LCD.
6.5 Distance Unit Setting for Instrument
Press the "UNITS"-button (6) longer to change the next type of
unit, m, ft, In, ft+In then continue to click the button for the next
unit selection.
6.6 Single Distance Measurement
Press the "ON/MEAS"-button (1) to the activate the laser.
Press again to trigger the distance measurement. The measured
value is displayed immediately.
6.7 Continous Measurement & Max / Min Measurement
The continuous measurement function (tracking) is used for the
transferring of measurements, e.g., from construction plans. In
continuous measurement mode, the measuring tool can be
moved to the target, whereby the measured value is updated
approx. every 0,5 seconds in the third line. The corresponding
minimum and maximum values are displayed dynamically in the
first and second line. As an example, the user can move from a
wall to the required distance, while the actual distance can be
read continuously. For continuous measurement, push the
"ON/MEAS"-button (1) until the min/max symbol is displayed or
the "Clear/Off"-button (5) again to stop the function.
-35-