VOLTCRAFT LCR-100 Bedienungsanleitung Seite 30

The test prods have to be removed from the measured object every time the measuring range is
changed.
Be especially careful when dealing with voltages higher than 25V AC or 35 V DC. Even at such volta-
ges you can receive a life-threatening electric shock when you come into contact with electric wires.
Check the measuring device and its measuring lines for damage before each measurement. Never
carry out any measurements if the protecting insulation is defective (torn, ripped off etc.)
Ensure that you do not touch the connections to be measured, even indirectly, during measurements.
During measuring, do not grip beyond the tangible grip range markings present on the test prods.
Avoid operation near strong magnetic or electromagnetic fields, transmitter aerials or HF generators
This could affect the measurement.
If you have a reason to believe that the device can no longer be operated safely, disconnect it imme-
diately and secure it against being operated unintentionally. It can be assumed that safe operation is
no longer possible if:
- the device is visibly damaged,
- the device no longer works and
- the unit was stored under unfavourable conditions for a long period of time or
- if it has been subjected to considerable stress in transit.
Do not switch the measuring instrument on immediately after it has been taken from a cold to a warm
environment. The condensation that forms might destroy your device. Leave the device switched off
and wait until it has reached room temperature.
Do not leave the packaging material lying around carelessly since such materials can become dange-
rous toys in the hands of children.
You should also heed the safety instructions in each chapter of these instructions.
27