Meec tools RMC300E20V Übersetzung Der Originalanleitung Seite 16

EN
E7
SV
NO
PL
E8
DE
FI
E9
FR
NL E13
E14
BP
EE
LOCK
STOP
The error code is shown after the
corrective tasks is done.
16
The tilt sensor is triggered.
The product is not correctly docked
to the charging station.
The product is trapped.
The battery of the product does not
charge.
The mowing area is to big.
The temperature of the battery is too
high or too low.
Unknown error.
Wrong PIN code has been entered
repeatedly.
The product is blocked and needs to
be released manually.
Push the power switch to stop the
product and put it on a flat,
horizontal surface. Then start the
product.
Make sure that it is at least 1 m of
straight perimeter wire and no
obstacles in front of and behind the
charging station.
Make sure that the charging station
is installed on a horizontal ground
and that it is flat.
Manually dock the product to the
charging station. When the battery is
fully charged, start the product.
Push the power switch to stop the
product and move it to an area
where there are no obstacles. Then
start the product.
Clean the poles of the product and
the charging station.
Decrease the mowing area to 300 m²
or less.
If the battery is too hot, let it to cool
down. Then start the product.
If the battery is too cold, let it heat up
to at least 5°C. Then start the
product.
Replace the battery.
Push the power switch to stop the
product and then start it again.
Refer to the supplier.
Release the product. Push the START
button and then the OK button, the
product will continue the operation.
Push the HOME button and then the
OK button, the product will go back
to the charging station.
Refer to the supplier or to an
approved service center.